UVB-1 2m3/hr

Descripción del producto

Installation bitumen grade UVB*1 is designed to produce both anionic and cationic bitumen emulsions, which are used in road construction :

for tack of the old pavement before applying them on asphalt ;

to prepare cold asphalt mixes ;

for the surface treatment of road surfaces ;

Device for thin coatings of protective layers ;

for patching roads etc.

 

technical characteristics

Parameter Value

1 Maximum performance (including preparation time ) , 3.5 m3/hr

2 Consumption of bitumen ( penetration at *0 ... **0 ) , not less than m3/hr1,5

3 Water flow m3/hr 0.6 ... 1.5 *

4 Flow breaker ( with penetration bitumen below *0 ) , dm3/hr 0 ... *0 *

5 Fuel acid dm3/hr 5 ... *0 *

6 Consumption emulsifier dm3/hr 5 ... *0 *

7 Consumption of adhesive additives dm3/hr 1 ... *0 *

8 Pressure bitumen at plant inlet , max 0.2 MPa

9 pressure is applied to the mixer bitumen , 1.4 ... 1.6 MPa

*0 The pressure of the aqueous phase supplied to the mixer , 0.2 MPa

*1 Temperature of bitumen entering the unit , ******0 C°

*2 Temperature of the water entering the plant , ****0 C°

*3 Lift height of the emulsion after installation (m) is not more than *5

*4 Installed capacity not more than *7 kW

*5 voltage power circuits at *0Hz, **0

*6 compressed air pressure , bar 4 ... 6

*7 Airflow, dm3/min **0

*8 Dimensions, mm , not more:

      - length ***0

      - width ***0

      - Height - ***0

*9 Weight, kg ***0

* Depends on the formulation of the produced emulsion