Globecore High Vacuum Transformer Oil Reclamation Plant Cmm-10.0

Descripción del producto

High Vacuum Transformer Oil Purification Plant model **0.0 purifies insulating oils of mechanical particles and employs thermal vacuum for water and gas removal. Operate the Unit when assembling, servicing and exploiting liquids filled equipment (power transformers, high voltage switches, etc.) up to ***0 kV of voltage.  Performance in a single pass through the purifier at a full flow rate shall be as follows: Water Removal: From *0 ppm down to less than 5 ppm in a single pass and down to 3 ppm after several passes as measured by the ASTM Method D***3 Gas Removal: From fully saturated with air (*0 to *2% by volume) down to less than 0.1% by volume as measured by the ASTM Method D****5 Particulate Matter Removal: *8% of particles over 1 μm Dielectric Strength: Improvement in dielectric strength up to *0 kV. 2. TECHNICAL DATA Parameter Value 1. Capacity, m3h - in degassing, drying and filtration modes *0 - in heating and filtration modes *6 2. Processed oil parameters*: - maximum gas content by volume, % 0.1 - maximum moisture content by mass, ppm 5 - filter fineness, micron 2 3. Maximum outlet oil temperature in heating mode, º¡ *0 4. Booster vacuum pump capacity, m³h ***0 5. Outlet pressure, MPa 0.4 6. Oil heater power, kWt **0 7. Maximum power consumption, kWt **0 8. Vacuum column max. residual pressure in degassing mode, Pa **7 9. Vacuum column max. residual pressure at air tightness, Pa *6.7 *0. Maximum inleakage within 1 hour of vacuum tightness check, Pa **7 *1. Voltage parameters, 3 Phase+N - voltage, V **0 - AC frequency, Hz *0 *2. Max. overall dimensions (with trailer), mm - length ***0 - width ***0 - height ***0 *3. Max. weight, kg ***0 *Note - For initial inlet oil parameters as follows: - gas content by volume less *0,5% - moisture content by weight less 0,*1% (**0 ppm) - while heating liquid in the unit to **0±*0 C for at least *0 minutes.