Descripción del producto

INSTAPLAST is a single component proprietary blend of powders based on Inorganic polymer technology mixed with graded sand that is water activated and used for vertical and overhead structural repair. The non-sag property of INSTAPLAST coupled with quick setting nature makes it ideal for vertical and overhead repairs without the loss of material.

MIXING GUIDELINES (at *0°C)

Add about **0***0 ml of water with 5Kg of INSTAPLAST and mix for 3 minutes. Initially the mixture may appear very dry. Keep mixing for about 3 minutes or until the slurry become warm as mentioned in the technical data sheet for ambient temperature lower than *0°C. The binder will slowly dissolve and smooth slurry will be formed. At this point it may be chosen to apply by hand or suitable applicating equipment.

The prepared slurry mix can also be sprayed by pouring the mix into the hopper of suitable spraying machine. Do not begin mixing until the spraying group people are ready to work. Try to avoid delays between spraying applications (down time when the material stays in the hose between applications). Remember to wash off all the equipment immediately.

INSTRUCTION TO USE

·    Do not split the content of a single packing. Mix the entire contents of a single packing at a time

·    Do not add excess water than specified as the material is very sensitive to water cement ratio

·    Mixed slurry should be applied onto the substrate immediately as the material tend to set fast

·    Wash off all the equipment immediately upon application as the material tend to set fast

WORKING TIME (at *0°C):

INSTAPLAST has an approximate working time of *0 minutes.

Hot Weather conditions: Working time will be further shortened at higher temperature site conditions. Working time can be marginally increased by using cold water for mixing, Can be further extended by adding proprietary retarder supplied by us, if required.

Cold Weather conditions: Working time will be extended at Lower temperature site conditions. Working time can be marginally shortened by using hot water for mixing, Can be further shortened by adding proprietary accelerator supplied by us, if required

The non shrink nature of INSTAPLASTalong with much closer co-efficient of thermal expansion with the host concrete helps in extending the durability of the repair mortar. INSTAPLAST has *0 minutes of working time plus additional *0 minutes to shape the repair to match the existing contours of the host concrete.

FEATURES

Quick setting

No priming or curing is required

Non shrink

High early strength

Superior bond strength with concrete

Not affected by Sulphate & Chloride

Non corrosive and Non flammable

**0% waterproof & Fire resistant

Suitable for extreme weather conditions

Highly Durable: As co-efficient of Thermal Expansion matches with host concrete

Prevents the reinforcing steel in concrete from corrosion

Very high bond strengths to properly prepared substrates

An Eco friendly product. Does not contain any cement or VOC’s

USES

Vertical and overhead patching of scaled and spalled concrete

Resurfacing of damaged concrete