GRAVURE INK PROOFER FOR WATER-BASED VASE INKS

Descripción del producto

1.        THE OPERATION SUMMARY:

1. The proofer should put on the solid flat place.
2. Install Gravure Proofing Edition:put the edge which is printed with specification on the distal,put the edge without word to flasten the proofing edition mount,compression screw.
3. Loosen the clamping lever,lift proofing moving frame.Attach the squeegee to the proofing moving frame,after fastening screws abut positioning pins.The beater backward is about *5 degrees,suitable compression screw fastening beater.
4. Push back the proofing moving frame in the end .Adjust the scraper adjuster and roller adjuster ,make sure the squeegee and roller could not touch the proofing edition mount.
5. Lower the proofing moving frame,lock the clamping lever,turn down adjuster(before adjustment loosen the lock ring at the bottom,adjust and then lock),so between close rubber roller and proofing edition has close suitable pressure(pressing proof can not be easily withdraw).Generally will increase by about 1 to 2 turns screw micrometer scale at the beginning of the rubber roller and pareller proofing edition after a clockwise touch,after India test case,as the leveling to do the approprite adjustments.
6. Adjustment downward blade adjuster(before adjustment loosen the lock ring at the bottom,adjust and then lock).So squeegee blade and proofing between version has a suitbale pressure (non-

1. Loosen tight grip level,confirm proofing moving frame has back foot,Proofing/Manual/Reset Knob in the manual position(center position).Power,turn on the power switch.First select 1 at the speed (*0m/min),the Sampling/Manual/Reset switch to the proof file,confirm proofing moving frame slides smoothly.Select the appropriate sampling rate(usually the beginning choose 3 position(*0m/min).such as the flow level after the test print is not satisfactory appropriate to reduce the sampling rate can be reset.
2. Proofing operation:The flexible substrate proofs suitable width and length(plastic film.cardboard,recommended **0***0mm size) with a transparent adhesive tape to glue roll (pasted along the direction of the incoming end of the can). Paste the terminal to the appropriate starting position (roughly in the vicinity of the beater), lock the clamping lever, the amount of ink placed on the blade near proofing Edition (concave-like at the beginning, close to the concave-like width not exceeding appropriate). The "Proof / Manual / Reset" switch to the "proof" position, proofing move forward quickly with the selected frame rate from the complete proofing Dodo.
3. Loosen the clamp handle, remove the proofs. Lift proofing moving frame and select "Reset" position to retract in the end (reset speed is factory preset good). Use a soft cloth with solvent ink residue scraper quickly, proofing version and the rubber roller cleaned in preparation for the next sampling operation. In the scrubbing process can be "sampling / Manual / Reset" knob to "manual" position (center position), so you can move back and forth freely moving frame proofing, easy to scrub operation. After completion of the reset proofing scrub moving frame.
4. observe proofs of printing effects, depending on the case proofing inks or equipment can make the appropriate adjustments.