250W Switching Power Supply

Descripción del producto

Enclosed Switching Power Supply **0W Series Outputs:
5V/*0A, 7.5V/*0A, *2V/*0A, *3.5V/*8.5A,
*5V/*6.6A, *4V/*0A, *7V/9.3A, *8V/5.2A

Features:
High efficiency, high reliability, low cost
Universal AC / full range
**0% full load burn-in test
Protections: Short circuit/ Over load/ Over voltage
Forced air cooling by built in DC fan
Built-in cooling Fan ON-OFF control
Fixed switching frequency at *0KHz
2 years warranty
Dimensions: **5***5**0mm(L*W*H)

Specification
Input
Voltage Range *0~**2 VAC / **0~**4VAC*7~*3 Hz; Selected by switch **4~**0VDC
AC Current 5.5A/**5 V 3.5A/ **0 V
Efficiency *4%(SP******5); *6%(SP******7); *8%(SP******2); *9%(SP******3);
*8%(SP******5); *2%(SP******4); *2%(SP******7); *3%(SP******8);
Inrush Current *5A/**5V*0A/**0V
Leakage Current <3.5 mA/**0VAC

Output: See the following form
Setup, Rise, Hold Time: **0ms, *0ms, *0ms

Protection
Over Load **5%~**5%
Protection type: Fold back current limiting, recovers automatically after fault condition is removed
Over Voltage **5%~**5%
Protection type: Hiccup mode, recovers automatically after fault condition is removed
Over Temp. L: RTH3≥ *5º CFAN ON ≤ *0º CFAN OFF, ≥ *5º Coutput shutdown

Environment
Working Temp., Humidity **0º C~**0º C; *0%~*0 %RH
Storage Temp., Humidity **0º C~**5º C; *0%~*5 %RH
Vibration *0~**0Hz, 2G *0min. /1cycle, period for *0min, each long X, Y, Z, axes

Safety
Withstand Voltage I/P-O/P: 3KVACI/P-FG: 1.5KVACO/P-FG: 0.5KVAC
Isolation Resistance I/P-O/P, I/P-FG, O/P-FG: **0M Ohms/**0VDC

Standard
Safety Standard Design refer to UL***0
EMC Standard Design refer to EN****2, EN****4, EN****0

Others
Weight 1.*5Kg
Packing *2PCS/*3.8kg /0.*8CUFT

Note
1. All parameters NOT specially mentioned are measured at **0VAC , rated load and *5º C of ambient temperature.
2. Ripple & noise are measured at *0MHz of bandwidth by using a *2" twisted pair-wire terminated with a 0.1μ &*7μ Parallel capacitor.
3. Tolerance: Includes set up tolerance, line regulation and load regulation
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.

For more information, please contact us.