Rust Protection Device

Description

Corrosion Control (E.C.C.)


Electronic Corrosion Control (E.C.C.) Module.


Electronic Rust Protection.


Corrosion Control Module (C.C.M.) Module.


Those are just few names this unit goes by.


Now, electronic protection is available for automotive vehicles. Electronic modules are installed in vehicles to supply electronic charges throughout the metal body to help protect against corrosion.


Benefits




•Replaces chemical-type rust proofing



•A clean & efficient way to protect your investment



•Lab & field tested



•Low battery shut off



•Does not interfere with computer or electrical systems



•Transferable from one vehicle to the next



•Suitable for new, pre-owned vehicles



•No re-application or touch-ups required



•Environmentally friendly     



•1 Year Manufacture Warranty







HOW IT WORKS Scientifically Tested!


The E.C.C. module is based on the principle that corrosion is an electrochemical reaction, oxidization, which can be controlled electronically. The rusting process begins with the loss of negative electrons that permit iron and oxygen to combine to form rust. The faster iron combines with oxygen, the faster the metal deteriorates. The metal body of a vehicle has a more positive electrical charge at the area where rust is occurring because electrons are robbed.


The electronic corrosion control process introduces a negative surface charge to the metal body which polarizes the microscopic layers of electrical charges that occur along a corroding metal surface. In essence the E.C.C. module makes it very difficult for the opposite charges of iron and oxygen to connect. Since they are hindered by polarized layers of charges, the negative surface charge - and its corresponding polarized charge layers - reduces the rate of which the iron and oxygen combine, slowing down the corrosion process. In other words, the Electronic Corrosion Control module makes it very difficult for iron and oxygen to combine to form rust.





THE TECHNOLOGY

Electronic Corrosion Control (E.C.C.) module is built with state-of-the-art microcomputer technology that allows the module to be digitally controlled. The module works by starting with a high precision signal generator. The tuned energy is applied to the coupling which is digitally monitored on a continuous loop. The energy is drawn from the battery, less than *0 mA, and passed with high efficiency from the pad to the vehicles body.


This technology, unlike a lot of other electronic rust protection units in the market, is not based on cathodic or impressed currents. Cathodic and impressed current technologies do not work on vehicles unless they are submerged in water or buried underground.


E.C.C. module has a self-diagnostic system built in! The unit can monitor leakage relative to the couple pad. Faulty signals or shorts are monitored and reported by the system; the system will automatically shut down until the fault is rectified.





  UNIT SPECIFICATIONS:


a)     Normal power supply*2 Volt DC. (minimum 9 volts DC. (Maximum *9 volts DC)


b)     Current consumption 0.*3 mille amperes. Just like digital car clock.


c)     Gray wire out put 2Hertz per second (electrons pumping on the vehicle body in Frequency)


d)     Red LED (still) for Power


e)     Blue LED (blinking) its showing device is working & pumping the electrons on vehicle body.




f)     In case of wrong wiring. No problem. We have reverse polarity safety in side of Module.