Cables and wires for oil and gas industry

Description

Cables and wires for oil and gas industry:
• cables for electrical submersible pump installations
• cables for well heating
• high-temperature cables
• heat-resistant cables
• heating cables
• winding wires.

Cables are designed to supply electric power to submersible electric motors of oil production installations, water lifting and pumping liquid from pits, reservoirs and ponds, designed for rated alternating voltage of 3.3 kV, 4.0 kV and 5.0 kV with 50 Hz frequency.

Design of cables for electrical submersible pump installations.
The cables are designed to supply electrical energy to submersible electric motors of installations for oil production, water lifting and liquid pumping from shot holes, tanks and water reservoirs; they are designed for rated alternating voltage of 3.3 kv, 4.0 kv, and 5.0 kv and frequency of 70 hz.


Design of cables for well heating.
The cables are designed for electric heating of oil, water and gas mixture in wells equipped with deep well pumps to reduce the mixture viscosity and to exclude the formation of paraffinic hydrate plugs and prevent the formation of asphalt resin paraffin substances on the walls of the pump and compression tubes.
 
Winding wires for electrical submersible motors.
The wires are designed for winding stators of submersible waterfilled electrical motors (oilfilled PPI, PPIN, PPIU, PPIUM) for longterm operation in water of artesian wells at a voltage up to 660 V and frequency of 4060 Hz.
 
Installation cable for electrical water submersible motors.
The cable is designed for connection to electrical networks with rated voltage of 380 and 660 V DC and frequency of 50 Hz of submersible electrical motors for longterm operation in water of artesian well at an ambient temperature from 40 °C to 70 °C.