Description
Before using the profile bending machine every day, be sure to pay
attention to whether there are damages in several places, such as:
mandrel, block, turntable, protective cover, etc., and confirm that
the test is correct and then start after the air conditioner runs
preheating and determines normal. Do the homework. When the profile
bending machine is working, it is necessary to insert one end of
the steel bar into the turntable and fix it in the gap of the
equipment, and the other end is pressed against the fixed part of
the fuselage by hand and then check whether the fuselage is fixed,
and it is determined that the steel bending machine is running
afterwards. . When using the profile bending machine, it is
necessary to strictly process the diameter, quantity and working
speed of the steel bar beyond the mechanical specifications.
Profile bending machine is divided into horizontal and vertical. It
can be divided into up-and down-down according to different shaft
arrangements. It is curved aluminum profile, flat steel, square
steel, round steel, angle steel, I steel, H Advanced machines for
profiles such as steel, square tubes, rectangular tubes, and round
tubes. Different molds can be customized according to user
requirements. The 4 rollers are all active rollers and are driven
by 4 independent hydraulic motors. The winding speed is fast and
the precision is high.
1. Equipment installation:
(1) Equipment installation should be carried out by professionals,
and installed according to the Mechanical Equipment Installation
Regulations.
(2) Dig the foundation according to the ground map of the
equipment, and then leave the second pouring hole according to the
map, then proceed
Second, equipment lubrication:
The main rotating part of the equipment adopts the internationally
advanced "oil-free automatic lubrication copper sleeve", and the
other operating parts can be filled with general lubricating oil
according to the situation.
Third, the operational preparation:
(1) Check if the power supply is safe, check whether the screw
connection parts are tight, and check whether there is any safety
hazard in the boom running area.
(2) First loosen the two overflow valve handles counterclockwise,
start the motor to see if the motor rotates clockwise, if there is
abnormal sound, if it can run normally for about 5 minutes
4. After the end of each shift, the piston rod must be cleaned and
the piston rod checked.
Fifth, carry out cleaning and finishing work
