Description
Product Description
HDPE pre-applied waterproof membrane is made of three layers
of materials，which are HDPE sheet, hot-melt pressure sensitive
adhesive, and isolating material respectively. And the isolating
material can be special sand(type S) and isolation membrane(type
M)
Product Properties
1.Pre-applied full-bonding installation: the HDPE pre-applied
membrane sanding surface up temporary fixed on the bottom cushion.
Direct binding reinforcement, and then poured concrete. The
membrane coated sand layer will combine with it tightly ,no water
moving between layers.
2.It has strong self-healing ability and can repair slight
construction injury.
3.High strength of elongation, strong breaking tensile strength and
good anti-perforation performance .
4..With strong chemical resistance to acid and alkali
5.Integration of self adhesion, waterproof and protection, so that
can reduce construction links
6.Wet method construction, no need flat layer, low requirement for
the base, not affected by weather and base moisture, it has obvious
advantage of constructions in rainy season.
7.The floor board of the building should be constructed with a
pre-applied anti-sticking method. This method no need protective
layer.
8. one layer can reach level one waterproofing security
requirements .
Classification:
S*-HDPE sheet with sand on the adhensive side.
M- with PE film on the adhensive side
Product Application
HDPE waterproof material can be used for Waterproof and
anti-seepage, caverns, tunnels, subway, bridge, water conservancy
dam basement, landfills, sewage treatment pool, municipal
construction.Root resistance can be used for all kinds of planted
roof
