UV tunnel drying oven, Drying production line, tunnel drying oven,

Description

Non - standard customization


Brief introduction of tunnel oven (line oven):

The outer shell of the tunnel oven (line oven) is made of A3 high quality steel plate. The inner liner is made of wire drawing or mirror stainless steel plate. The shell surface is sprayed with plastic / environmental protection paint, and the shell is filled with aluminum silicate fiber between the outer shell and the inner liner, forming a reliable insulation layer. The tunnel oven can use teflon or metal belt conveyor belt. The heating pipe is installed in the top air duct (or both sides of the air duct). The room temperature is **0 C to **0 C. The oven door is sealed with silicon rubber strip and the side opens to facilitate the later maintenance.


Use and pay attention to:

1. The main transmission of the tunnel oven is the stainless steel chain or stainless steel mesh belt, which is used for the production of different products. It can adjust the suitable running speed arbitrarily according to the different requirements.

2. The heating element of the tunnel oven is made of stainless steel heating tube (long service life, not easy to break in transportation) / high quality milk white quartz glass tube or far infrared directional radiator as heating element. It has the characteristics of high radiation coefficient, low energy consumption, fast heating up and small temperature impact.

3. The air inlet of the tunnel oven is equipped with a high efficiency filter to purify the air sent into the air, and at the same time, the exhaust vent also has a high efficiency filter to prevent the unclean air from reflux. At the same time, the air flow rate of the butterfly valve is high. The machine has preheating area, constant temperature area, cooling area and cooling area. The temperature range is ***0 ***0 and room temperature.

4. In addition to the frame of the tunnel oven, all the stainless steel is made of stainless steel (according to the requirements of the customer). The insulation material is made of aluminum silicate fiber, which has the advantages of good thermal insulation and so on.

5, another power distribution control cabinet is equipped with a voltmeter, ammeter and digital display temperature controller, and also equipped with electrical governor and other electrical appliances to ensure the normal operation of the machine.


Technical parameters: