Description
The switch actuators are the modular installation devices, with 8
and *2 outputs for selection, using EIB bus
connection terminals to connectÂ
to the system. The switchÂ
actuators need to connect an extra **0V AC power
supply and provide to 4 outputs. It is able to use the Engineering
Tool Software ETS (ETS2 v1.3 or later) with a
VD2/VD3 file to allocate the physical address and set the
parameters.
If the **0V AC power supply isÂ
not connected, all LEDs are flashingÂ
for indicating output state onÂ
the
device.
It is able to switch from 4 to 8 independent electrical AC loads or
three-phase loads and 4 electrical AC loads
with the same phase of the **0V
AC power supply by the switchÂ
actuators with maximum output ofÂ
*6AÂ per
output and manual switch, as well as visible switching status via
LED indication.
There are same following programming functions for each output:
ï·Â time function: on/off delay
ï·Â staircase function with the warning and adjustable
staircase lighting time
ï·Â scene, preset control: 8bit/1bit
ï·Â logic operation: AND, OR, XOR, gate function
ï·Â status response
ï·Â forced operation and safe function
ï·Â threshold function setup
ï·Â control of electro thermal valve function
ï·Â manual operation switch
ï·Â indication of switch status (contact position)
