1, about the " shaker ": This is the name of all vibration screening equipment products, exactly this circular vibrating screen according to the national related standard called " rotary vibration sieve ", because of its vibration operation principle of a lot of enterprises is also known as the " three yuan vibration screening filter ".
In 2, working principle of vibration screen: the vertical vibration motor as vibration source, motor, installed at both ends of the eccentric weights, motor rotational movement into horizontal, vertical, the tilt of the three yuan movement, and then passed to the campaign screen. Regulation, on the lower ends of the phase angle, the screen can change the material 's surface movement.
4, vibrating screen used in the industry:
Chemical industry: resin, paint, industrial medicine, cosmetics, paint, medicine powder.
Food industry: sugar, starch, salt, rice flour, milk powder, milk, egg, soy sauce, juice.
Metal, metallurgy mining: aluminum, lead, copper, ore, alloy powder, welding rod powder, manganese dioxide, electrolytic copper powder, magnetic material, powder, refractories, alumina, kaolin, limestone, calcium carbonate, such as Ishi Eisa.
Processing: waste oil pollution, wastewater, dyeing wastewater, additives, such as activated carbon
In 5, the installation and debugging of vibration sieve:
( a ) the equipment should be stable foundation. When the device is installed on the ground or on the basis of general cement, can not set anchor bolt. When the device is mounted on the steel structure stand, application of bolt in structure, and steel structure rack should have a certain degree of steel.
This machine only needs to switch a ( Note: it is best to use electrical control panel ), with flexible pipe threading, the motor is connected to the power supply, pay attention to electric control panel shall be suspended mounted on wall.
( two) equipment factory before the screen install, use process screen replacement may be his replacement.
( three) before the start, should first check the compaction bolt fastening degree, and the feed inlet position and whether the receiver is observed, and the vibration motor can rotate normally and spring force without obstacles, check whether the pressure of each layer of screen mesh.
( four) when the rotary vibration sieve access electrical control panel before, should be the first on electrical control panel for examination. Closure of the line was observed after vibration motor direction of rotation is clockwise, ( Note: it should change the phase sequence ) is functioning properly, has no noise.
( five) to adjust the vibration motor eccentric block of phase angle, to adapt to all kinds of material screening conditions.
