XH-30 Laboratory Plastic extruder

1. Screw diameter：￠*0mm 

2. L/D：*5

3. Max Speed of Screw : **7rpm

4.Power of main motor: 5 HP,Ac frequency conversion.

5. Feeding motor :1/2HP                                                             6. Screw: the screw is made of good nitrided steel(*8CrMoAl)                                                7.Barrel : SACM***5                                                   8.Heating mode:electrical heating,three sections of temperature control.                                                           9. Temperature: room tempe ～**0℃                                                                 *0. Cooling mode: Electromagnetic valve controller, one section water cooling                                                           *1.Transmission Equipmen:Hard-toothed surface transmission box,smooth running, low noise, high transmission rate, high reliability.                                                         *2. pressure sensor: melt pressure sensor on the handpiece.                                                             *3.Power: 3∮，AC**0V                                       *4.Wght: about **0KG