Description

1

• CAD Designed
• Adjustable Stop Points
• Maintains factory safety, accessories & function
• 4 Heavy duty Gas Struts
• Detailed Instructions
• 3. Installation:
   
  16. Extend all wiring running into the door, to allow for vertical travel, (solder all connections to prevent electrical problems) open and raise to measure for wire length. Remove wires from the loom and cut. Cut on wire at a time to prevent mistakes. Solder the appropriate extension lead and tape/heatshrink. Repeat with all wires. A longer wire loom may be needed.
  17. Make all the proper adjustments, to allow for smooth opening and closing operation. See Fine Tuning section below.
  18. With door open, attach strut to the hinge, locate and mark mounting position for ball stud on chassis.
  19. Attach ball stud to chassis using either the supplied mount or fabricate one for your specific application.
  20. Re-attach fender and all parts, that were removed and test motion.