Description

Introduction
This product is a bluetooth remote control self-timer using for mobile phones, without installing any software.It can be used for iPod/iPhone/iPad,i***0/i***0/i***0/i***0/i***0/note2/note3,HTC-G*4/Rezound/G*2,Millet mobile phone and other brands of some android system mobile phones.
1,Built-in lithium battery,could be take photo ****0 pictures after fulling charge.
2, Long distances for use, up to *0 meters.
3, Five function keys: powerON/Off, Bluetooth pairing, camera, Android configuration, IOS configuration.
4, Strap hole design, easy for carry.
5,IOS system just compatible above 5.0 versions.
Accessories：
Micro USB cable×1
Electronic paramater：
Battery capacity：**0mAh；  Charing voltage/：DC5V/**0mA； standby current：**0μA； working current：3mA

User Manual
1 Press the power button,LED light flashes;
2 After switch on,then press the Bluetooth pairing button until the LED flash slowly, this means it is in bluetooth searching or pairing ;
3 Use mobile phone for pairing, when it is successful, the LED will extinguish;
4 Press the corresponding key for mobile phone system configuration, LED will be flashed after the configuration is completed, then it can be used normally.
5 It will enter into the sleep mode automatically without using for 5 minutes.Please press the power button to turn off the self-timer, to ensure the battery can be used for a long time.
6,use PC device or mobile phone power adapter to charge the product, charging LED long bright, saturated LED will extinguish;

Attention
  
1 Do not use chemical solvents to clean the product.
2 Do not spill strongly acidic agent, apply to the product.
3 Do not place the product in hot or into fire.
4 Do not squeeze or not drop the product.