Description

Impact Devices:

• 
  
•  

  D-Probe:

   

  Universal standard unit. Will handle the majority of hardness testing applications.Weight: *5g

   

  Model No. PHT*******0

   

   

• 
  
•  

  D**5 -Probe:

   

  Very narrow contact area with a set back measurement coil. This device is used to measure hardness in grooves and recessed surfaces. Weight: *0g

   

  Model No. PHT*******0

   

   

• 
  
•  

  DL -Probe:

   

  This model features a needle front section with a diameter of 4mm and a length of *0mm. It is suitable for testing in extremely confined spaces, the base of grooves and on special components such as as gear wheels. For use on steel and cast steel only!

   

  Model No. PHT*******5

   

   

• 
  
•  

  DC-Probe:

   

  Very short impact device for those confined areas, i.e. inside bores for internal measurements. Conforms to the D measuring range. Weight: *0g

   

  Model No. PHT*******0

   

   

• 
  
•  

  G-Probe:

   

  This device has an enlarged test tip, and an increased impact energy range (approx. 9 times the D, *2 ft-lb.). Can be used on lower quality finishes for measuring hardness in the Brinell range only (max. **0 HB). Designed to be used with heavy components such as heavy castings and forgings. 
  
  Weight: **0g

   

  Model No. PHT*******5

   

   

• 
  
•  

  C-Probe:

   

  A reduced impact energy impact device(approximately ¼ of the D Type 2 ft-lb.) for measuring the hardness of surface hardened components, coatings, thin wall or impact sensitive components. Applies a small superficial indentation. 
  
  Weight: *5g

   

  Model No. PHT*******0

  
  For Testing on Round Parts
• 
  
•  

  *2pc Universal Support Ring Set For Portable Hardness Testers

   

  This set is designed to let the user confidently test on round (Concave or Convex) parts. Simple threaded design for quick change in the shop or out in the field.

   

  Model No. PHT*******0

•