Sell 15kv high frequency spark tester

Description

 High Frequency spark tester is a efficient and  reliable product inspection tool, a precision instrument to detect various types of wire and cable the conductor insulation layer of pinhole, broken skin, bare copper and so on poor insulation points. It can quickly detect the layer defect without damaging the inner electrical conductor.  Use high frequency (3KHz) high volt elctrode replace traditional (*0/*0Hz) high volt electrode, its electrode tip can select a *0mm beaded -contact , copper brush , carbon  brush, or a roller , greatly smaller installation dimensions , greatly improved detection speed ( ***0m/min ). This high frequency spark tester is a reliability high quality control tool.
 

Fuctions：

1.this tester return detecting 0.1s after conductor fault detected.

2.electrode tip size is *0 times smaller than traditional electrode tip(*0Hz).

3.test voltage adjustable from 1.0 to *5K VR.M.S.

4.the instant sparks will not destroy the good insulation of wire comductor.

5.limited fault current, will not damage the test equipment.

6.rapid detect pinhole and nonintact wire conductor fault.

7.Closing lines or host failure or start -linked signal control .

8.with safety switch interlock protection device.

 

 

1.comply with the requirements of GB/***8.***4. JB*****0、VD***1、EN****6、BS***9、CCC and so on standards. Detection sensitivity

2.Meet the requiremetns of UL********0.

3.this instrument adopt oil-immersed or epoxy resin casting ignition coil, product can be detected with water, and a self-test device can detect weather the instrument is working properly(breakdown, counting, sound and light alarm)
note: UL or new GB standards instrument please special statement.(special specifications can be made to order)

 

SCR**5A HF spark tester specifications:

test voltage:AC 0.5－*5KV  

Effective detection voltage：AC0.***0KV 

AC pluse factor：les than 5% 

Breakdown sensetivity：I=**0±*0uA，t≤0.**5s  

Sensitivity range：**0－***0uA

Power supply:AC**0V ±*5%  

Short-circuit current：3－4mA  

Max breakdown count frequency：*0 /s    

Max test speed：***0 m per min  

Electrode size: *0mm

Voltage stability：power input ±*5%, output be constant 

High volt test electrode tip: Bead/copper brush/carbon brush

Max cable diameter：ø4mm     

Output frequency:2.5～3.5KHz   

Output control:relay output 5A/**0V                       

Weight:controller displayer  6KG ,high volt test head  6KG.