Description

dental polishing lathe

dental polishing lathe for lab ZB-PMJ

This polishing machine is widely used to cutting and polishing all kinds of metals in prosthetic 

dentistry,eg:nichrome,cobalt-chromium alloy,stainless steel material,flexible denture,bridges and porcelain teeth.



Main technical parameter:

Voltage     :**0v
Frequency   :*0hz
Power       :**0w
Package size:**0***0***0mm
Rotage speed:***0 rotate/minute
Clamp       :spiral type
 

Caution.

1. Please operate it with the voltage and frequency stipulated on the rating label of the machine.
2. Before operate the machine, the crust should connect the earth.
3. Please operate the machine far away from the gas that flammability and easy to explode.
4. Prohibit knocking down the safety guard to operate.
5. Do not operate it outside.
6. Please operate it far away from drenched world.
7. Please do not let the children close to the operating machine.
8. The rotating direction of the machine should be same to indicator drop.
9. The operator should wear goggles or dustproof glass.
*0. When operate the machine, please do not let the workpiece clash into grinding wheel , to avoid the grinding wheel break 

up and hurt people.
*1. When finish operation and power off suddenly, you should turn the switch to the close position, to avoid to startup 

suddenly and hurt people.

 

The operation of the machine 

1. The machine can be used on the place of altitude not exceed ***0 minutes, environmental temperature between *5°C****5°C 

and surrounding comparatively humidity ≤*5%.

2. Before use the machine, please check every accessory carefully, if damaged during transportation or the fastener is not 

hard up or not. If yes, it should be repaired and fastened. 

3. Before use the machine, should turn the axis of rotation by hand, it should be agility without scuffing. If have scuffing, 

should find out the reason and eliminate it, only after that, the machine can be used.

4. The machine equipped with 2pcs polymethyl methacrylate plastics safety-guard glasses, connect with the bracket of the 

glasses, then mounted it on the grinding wheel shield shell. You can adjust the point of view according to the requirement to 

achieve the dustproof function.(for polish machine III)

5. The pedestal of the machine have fixing hole, when necessary it can be fixed with a bolt to use.