Description

Introduction:

HM***0 is compatible HID iclass card reader, it is a solution that one reader can read the most common RFID and ISO***3A, ISO ****3 protocol. It reads all HID standard iclass card serial number also mifare IC, I-code, Tag-it RFID CSN number.
HM***0 is with external LED and buzzer control function, and it has special one hold control line which allow access controller host to stop HM***0 from detecting card.
HM***0 is good solution for using HID iclass card with low cost.

Specification:
support card :HID iclass card serial number, Mifare smart IC card ****3A, Desfire, I-code, Hi-tag
Power requirements:***6VDC at **0 mA
interface:wiegand*6 or Wiegand*4
Reader range:5 to *0 cm
Frequency:*3.*6MHz
Operation temperature:**0°C to **0°C
operationg humidity:5%**5% (non-condensing)
Audio/Visual Indication:Green & Red and Buzzer signal output
Protection:ESD, Suger protection
Dimension:*6W x **1H x *2D (mm)
cable length:**0mm
Weight:**0 gram

LED function: Normally,LED color is in RED. It starts with 1 time green flashes when power on and will keep RED. When put cards close to the reader, LED will flash green momentarily, this indicates card was read properly. When LED control signal is actived, LED will change to green. The LED control signal is from host panel.
Beeper Function: When power up the reader, the beeper will ring 1 time. When put a card close to the reader, a short beep will be emitted. This indicates that the card was read properly .