Description
. Precise stable water temperature: As used for industrial cooling,
Low temperature water which produced by warter-cooled chiller could
send to the equipment and containers directly which need to be
cooling. 2. Y-depressurization start mode: Half a dense screw water
chiller use Y-depressurization start mode. 3. Capacity adjustment:
Screw water-cooled chiller according to the use of Client load can
automatically adjust load capacity. The standard chiller capacity
adjustment method using segmented or non-polar uninstall way.
Single machine can realize the four sections of compressor capacity
**0%**5%**0%**5%. 4. Perfect protection function: Screw
water-cooled chiller have perfect protection function, such as
power wrong phase lack protection, System high-voltage protection,
System low voltage protection, Double antifreeze protection,
Compressor overload protection, The insufficient frozen water
cooling protection, Prevent frequent start protection, Compressor
built-in exhaust temperature and coil overheat temperature
protection and so on. 5. Meet the temperature requirements of
various industries: Screw chillers in the use of industrial cooling
can be applied to a variety of cryogenic cooling, add the
appropriate antifreeze in the chilled water side can be achieved 0C
to - *5C the water temperature to suit different industrial cooling
requirements 6. Higher cooling energy efficiency: As the use of
central air conditioning with air - conditioned boxes, fan coil and
secondary heat exchanger used in conjunction with, cooling energy
efficiency ratio is the biggest advantage of the water-cooled
chillers. 7. External water-cooled plate oil cooling device: In
order to more fully the frozen oil and refrigerants separation, Low
temperature cold water chiller external centrifugal efficient oil
separator, it Can greatly reduce in low temperature and stranded in
the evaporator of frozen in oil. To ensure that the compressor
lubrication system security. At the same time also improves the
heat transfer effect of the evaporator. 8. Plus liquid spray
technology: To further ensure compressor motor not overheat, Screw
water-cooled chiller use plus liquid spray technology, with low
temperature cold media on the motor cooling directly. To ensure the
long-term and stable operation of the compressor. 9. Green
environmental protection: In order to better protect the
atmosphere, it Can producte green environmental protection etc
cooling medium refrigeration and air conditioning equipment not
only in adopts HFC**7C and HFC**4A, but also in HCFC*2. *0. Balance
run: Many of the chiller with compression, microcomputer automatic
memory will be per compressor operation time, start the next time
it will be activated running less time compressor. *1. Remote
control: Each chiller with remote control function, the computer
controller is equipped with RS**5 communication interface
standards, open communication protocol, all kinds of building
monitoring system connected even remote different ground
monitoring. *2. Cold water chiller recyclable: In today 's
increasingly tense energy, waste heat use will have long-term
economic value, on this basis, the Division I developed a heat
recovery chiller can be full recovery of the original go condensing
waste heat released into the environment. *3. Waste heat &
secondary condensation: Rely on waste heat generated when the pump
cooling system to take domestic hot water, without additional
consumption of electricity, fuel; Almost zero cost; No pollution,
no need to add other devices, just access to water pipeline, direct
access to hot water.
