Description

Polished Stones methods:
First, the preparation of pre-Stones
1. First select the qualified and skilled construction team, and to the construction asked to explain in detail the construction side in order to avoid problems due to the impact of construction Laying effect.
2. According to design requirements, according to tile number, color pattern Stones, such as irregular pattern of products should be based on the direction of Paving bricks at the end of the arrow.
3. The product if any adverse conditions please immediately notify the company to, once Stones, regret that responsibility.

Second, the construction should meet the following requirements
1. Using **5 # ordinary portland cement dry shop, cement volume ratio of sand to take: 1: 4 - 1: 6 between the mixing of sediment to mix evenly, forming layers degree *0mm**5mm.
2. Combined with the ceramic tile floor should be smooth, with thin fishing line to fight cross accurately identify the flat water.
3. Paving the surface when the tile should be maintained clean, flat, mosaic correct, when the brick used in adjusting the rubber mallet to be wrapped with a cloth to prevent the rubber DIP in the brick; In brick with a hammer percussion to be used **0 * **0 * *2mm of clean wood separated to avoid a direct hit brick hammer arising from breakage or damage, Stones to follow the course of the design requirements, when the design requirements have not been left seam, generally Welds width should be controlled better in the **3mm.
4. Tile laying of the surface layer, its brick surface should be protected until the combination of layers of cement mortar strength required before it can reach the surface of talc addition to wax clean, clean, professional cleaning team the best choice, in addition to post-wax with a clean clearing the ground of cotton dust, (avoid wiping with wet Butuo brick, dirt and water to prevent sticking to the surface difficult to clean brick), and then waxing, we recommend waxing once a month maintenance to keep the product gloss. )