Description

Model:  AK-RK*1S**2

Name: *2V single channel, multifunction and small remote switch

What you are viewing is a DC *2V Wireless Remote Control Switch.This is a **0% brand new wireless remote control switch. This Wireless Switch is a high-security, large memory capacity, stable performance, low power consumption of the features, and easy to use. This High-security Wireless Switch is convenient for customers to use and the material is good. This DC *2V Wireless Remote Control Switch can be used in wide area & also avail for the public to buy it
Specifications:

Operating Voltage: *2V DC

Operating Current: ≤ 6mA

Operating Frequency: **5,**3 MHz

Operating Temperature: **0°C ~ **0°C

Receiver Sensitivity: ≥***5dBm

Output Voltage: AC / DC (optional)

Output Current: ≤ *0A

Size: *8.2 x *2.8 x *5mm/1.*9 x 1.*9 x 0.*9in(L x W x H)

Features:

This Remote Control Switch is designed with a high-security & large memory capacity

This Remote Control Switch is also stable performance & low power consumption

This High-security Wireless Switch is convenient for customers to use and the material is good

This DC *2V Wireless Remote Control Switch can be used in wide area & also avail for the public to buy

Details:

This Wireless Switch is a high-security, large memory capacity, stable performance, low power consumption of the features, and easy to use

This High-security Wireless Switch is convenient for customers to use and the material is good

This DC *2V Wireless Remote Control Switch can be used in wide area & also avail for the public to buy

Size in Detail:

How to Build a Wireless Remote Control

Simple wireless devices use various components to activate an infra-red signal that broadcasts to a receiver box, allowing the user to program the control. Basic wireless remote controls simply turn a device on or off. Components used in a wireless device can be found at most electronics outlets and hobby shops. Specialized retail establishments have pre-packaged kits that can be used by a beginner. At the very least, even experienced electronics enthusiasts use pre-made remote control boxes due to the simplicity of their design, including ergonomic support. The structure of the wireless remote control provides a builder with not only knowledge but the reasons a receiver can be controlled by the device

Instructions:

Open the remote control housing and place a push button switch on the side. In the upper right corner of the housing, fasten a *-volt battery holder. Be sure enough room is available to install and remove the battery

Run a wire from the push button switch and link to the *-volt battery holder at the negative connection. Attach another wire to the push button switch and lead it to the Meg 1/4W resistor and the NPN silicon transistor. Run a third wire from the Meg 1/4W resistor and attach it to the *2K 1/4W resistor and and the PNP silicon transistor

Position the infra-red LED on the front of the housing. Attach the LED and run wires to both transistors. From the *2K 1/4W resistor, run a wire to the C**0.*1uF *6v ceramic disk capacitor. Run another wire between the NPN silicon transistor and the ceramic disk capacitor

From the positive connector on the *-volt battery holder, connect a wire to the PNP silicon transistor. This will allow for proper current flow in a closed circuit. Ensure the push button switch is positioned to "off" and place a *-volt battery into the holder. Close the remote control housing

Point the remote control at a receiver, making sure the LED on the control is aimed at the LED of the receiver. Push the button and the receiver should power on and off. To adjust the receiver to be programmed, point the remote control and hold down the push button switch. Adjust the pot or taper on the receiver

Package Included:

 1 x Wireless Remote Control Switch with cover