Description

Garage Door Controller, 3 Channel Remote Controller

Working Voltage: DC*2/*7V
Working Current: *2mA
DC/AC Control Voltage: DC*4V /AC**0V
DC/AC Control Current: DC*0A/AC*0A

1. Terminal Block XS1: From up tp down:
HL: Light control switch, the highest control Voltage is AC**0/*0W;
N **0 L input: Input power, connecting **0V;
TC1: Transformer primary, connecting power transdormer\'s output **0V;
2. -MOTOR + terminal: Electric Machinery Output, connecting electric machinery. Pay more attention to the polarity of electric machinery. If the electric machinery operate in opposite direction, only exchanging these two terminals;
3. AC*4V terminal: Transformer secondary, connecting power transdormer\'s output AC*4V
4. +BAT- terminal: Connecting backup power, *4V storage battery, down is "+", up is "-";
5. XS2 terminal: Connceting with display screen;
6. SPEED speed check terminal: Electric Machinery speed checking signal input, used for testing travel route and motoricity. From down to up the sequency is: *5Vsignal input terminalearth terminal;
7. pH Photoelectric switch: Selection function of Photoelectric switch. When connect 1 and 2 pin, it\'s workable for Photoelectric switch.
8. Automatic door: Selection function of automatic closing door, when connect 1 and 2, it has automatic closing door function, if connect 2 and 3, it has no such function.
9. ANT1: Used for connecting receiving antenna.
*0. RECEIVER High frequency board: Connecting high frequency receiver board;
*1. W1: Adjusting the bounce of closing door. (INC) direction means enlargement, (DEC) direction means decrease;