Description

Boron Carbide Sandblasting Nozzle

More informations,please contact CHARLIN(AT)INNOVACERA(DOT)COM

Hot-pressed boron carbide is one of the hardest materials available in commercial shapes, and gives outstanding resistance to abrasive wear.

This fully dense boron carbide is produced by hot pressing and is characterized as follows:

Light Weight
High Hardness
Erosion Resistance
High Modulus
Neutron Absorber

It can be polished to a mirror finish and has good resistance to acids. It is refractory and chemically inert, but less resistant to oxidation than silicon carbide.

Boron Carbide tends to contain second-phase graphite and it is this property which has a major influence on the strength of the material.

The composition ranges from B4C at *8.*5 wt% boron to at least B6.5C at *5.4 wt% boron.

Production of Boron Carbide

Commercial boron carbide is produced by reacting and fusing boric oxide and carbon, in an electric arc furnace.

Boron carbide does not melt congruently, therefore the liquid in contact with the boron carbide, does not have the same composition as the solid. This means that the liquid must be solidified at a rate so that the liquid and solid don"t reach an equilibrium.

The material which is in a molten state becomes increasingly rich in carbon, therefore when the liquid solidifies its composition is one of boron carbide and graphite.

Hot pressing (including hot isostatic pressing) is a way of producing covalent ceramic materials such as boron carbide, which are fully dense and in pure single-phase form.

Hot pressing limits the size and complexity of shapes which can be produced, to shape these diamond grinding is used.

Properties:

Low thermal conductivity

Susceptible to thermal shock failure

Outstanding hardness

Extremely brittle

Semiconductor

Good thermal-neutron capture

Typical Uses:

Thermal-neutron absorber

Loose abrasive

Nozzles for abrasive slurries

Wear applications (Load compressing or sliding)

Special Parts welcome OEM.

5.Innovacera can supply many kinds of Boron Carbide parts according to the customers' differents requirements. Our products include the boron carbide plunger, c boron carbide  plunger pump, boron carbide  rods,ceramic tube , boron carbide pipe ceramic shaft, ceramic piston, ceramic water valve sheet, ceramic pipe sleeve, ceramic loom plunger, ceramic seal ring, special shape ceramic, ceramic knife etc.

6.Also Innovacera have our own factory,Our factory is located in Zhangzhou

 Now our Office

We are specialized in the Ceramic tubes manufacturing.If you need any help about is,please don't hesitate to contact with us.