Description

Volvo VCADS3

Volvo Interface *******0 is developed for Volvo/Mack Vehicles and Egnines.

The *******0 communication unit enables PC to vehicle communication. The device connects to the PC via a USB cable or by wireless LAN using the **2.*1 b/g standard.
Operating temperature range: **0 to **5° C (**0 to ***5° F).
Storage temperature range: **0 to ***5° C (**0 to **7° F).
Before the *******0 communication unit can be used, a driver must be installed on the PC. In addition, a utility application (Admin***0) can be used to check the status of the device and update the firmware if and when needed.
There are three different ways, described below, of connecting communication unit*******0.

Via USB-cable
Connect the communication unit to the vehicle.
Connect the USB-cable between the communication unit and the PC.
Select communication unit *******0 and USB-cable setting in window Alternative.

Directly to the communication unit
Note: Your PC must have Wireless LAN **2.*1b/g and support for **8 bit WEP (encryption), if it is to be used for direct communication with the communication unit. The Panasonic CF*9 has this built into the motherboard. Additional Wireless LAN cards will be recommended in the future.
Connect the communication unit to the vehicle.
Select communication unit *******0 and Direct to communication unit in window Alternative.

Security level Directly to the communication unit
Communication is performed using **8 bit WEP, Wired Equivalent Privacy. The WEP-key is generated automatically and is not seen during the configuration.

Via an access point
Note: Contact the local IT-support or network technician before installation.
Connect the communication unit to the vehicle.
Select communication unit *******0 and Via an access point in window Alternative.

Security level Via an access point
There are three alternatives for this:
WEP and MAC-address. Communication is performed using **8 bit WEP, Wired Equivalent Privacy. The WEP-key is written in during configuration. The MAC-address is to be written into the access point for additional security.
WPA and PSK. Communication is performed via WPA, Wi-Fi Protected Access.
**2.1x. Communication is performed using standard EAP_MSCHAP v2. The communication unit is then treated as a PC and will be logged on to the network using a username and password.

Product description for communication unit *******0
Communication unit *******0 has a number of different coloured LEDs. These LEDs show the status of the communication unit and indicate warnings, etc.

Set includes
1. VCADS/ (PPT 1.*2 version(Premium tech tool))
2. Volvo interface *******0 - genuine (new)
3. Volvo 8 pin cable (new)

Languages: English, cesky, dansk, Deutch, Espalol, Francis, Italiano, Magyar, Nederlands, Polski, Portuges,
Romana, Srpski, Svenska, Turkce, Russian, Lietuva, 4x Asian, Arabic

mail: autodiagnosis1 AT autodiagtool DOT com

SKype: laural_luo  

MSN: laural_luo AT hotmail DOT com

Cell: **6 **********2