Sell Round LED Panel Light Dia175mm

Description

LED Light Panel Dia**5
Body size: Dia**5x*3mm; Light Area Size (mm): dia**5mm
Input voltage: ******0VAC
Power Supply: External; Consumption Watts: *6W; Current: **0mA
LED type: Epistar SMD; LED quantity: *6pcs
Working Temperature:**0℃**0℃; IP Class: IP*0
Warm White: ***0K, **0lm; Natural White: ***0K, **0lm; Cold White: ***0K, **0lm

Packing: *0pcs/ctn, G.W.: *2.0kgs, carton size: *0**7**5cm

Warranty: *4 months

1). Aluminum housing with white outer surface, ultra thin design conception

2). Color option: White or Silver

3). Matched with a high efficiency constant current driver

4). Energy saving, low heat, no UV or IR radiation, no mercury

5). Recessed installation

6). High quality PMMA diffuser with over *0% light transmition achieves even and soft light output

7). It adopts *6pcs 0.5W LED as luminous body, matched with high efficient LGP and elegant aluminum housing which emit high light output. 

8). No glaring, stable quality and long life span, 

9). It can be installed into ceiling or wall as a replacement of traditional downlight

*0). It is widely used for hotel, restaurant, commercial and residential lighting.  

Installation:

1. Turn off the power.

2. Drill a suitable mounting on the ceiling according to the light's cutout

3. Connect input end of LED Converter to commercial power (**0V***0V), make sure connecting is right.

4. Put LED driver at a suitable place on ceiling

5. Pinch both springs (showed as 1), then push light into installation hole (showed as 2), make sure the light fixed well.

6. Re-checking everything was connected well before turn on the power

Application:

Hotel, Meeting Room, Office, Hospital, School and places where energy saves and high color rendering index lighting needed.

Notes

The panel should be driven by appointed power supply.

 Protection film should be removed after installation to keep the panel clean.

To avoid electric shock, keep power off before installation and maintenanceInstallation and maintenance must be done by profession electrician, the non-professional operators are not allowed to take apart the lights