Description
Serrated Steel Grating
1. Indicate material of grating, size of load bar and the surface
treatment method.
2. Select suitable type of grating according to load table.
3. Indicate requirements of banding and cut-put position.
4. Offer the size, quantity and direction (span direction, normally
written at the back, followed with "LB ").
5. Where any large area of grating application is required, please
provide the following information in the drawing for the purpose of
layout design:
All dimensions.
Load bar direction, location and section size of support steel
direction of V-iron.
Location and size of movable area and cut-out.
Location and size of' kick plate, front nosing and splicing.
6. The grating is generally priced by square meter according to
area calculation standard of' YB/T***1.*****7, i. E. Max size of'
exterior, including holes and cut-out. Ect.
7. Reasonable alignment of grating.
For example: When using G**5/*0/***-G grating on a ***0x***0mm
platform, generally the design of load bar will be based on the
short span(***0mm), moreover, some clearance should be left between
gratings for installation. Grating layout on this platform is shown
as figure below .
