Description
LEXIA*3 Interface latest
version, works for both Citreon and Peugeot!
Dealer diagnostic scanner for comprehensive Citroen and Peugeot
cars diagnostic. You can do all as a authorized dealer does.This
diagnostics software allows you to perform complete diagnostics of
all from ***5 untill present models. Diagnostics is performed via
OBD-II connector (which is located near steering wheel) or via
manufacturer-specific connector (only older cars, pre****1).
Supported functions
Unlike other
universal car scanner tools which only read fault codes, this
software performs nearly ALL the functions like the original dealer
diagnostic tool. Our diagnostic interface contains K-Line
multiplexor, CAN-BUS interfaces and SAE J***0 bus (both PWM and
VPW).
The
following diagnostic functions are
supported:
Read identification
Displays complete identification of control unit, e.g. part number,
software/hardware version, manufacturer, etc...
Read fault codes
Displays all stored and pending fault codes with complete
description (e.g. "Rail pressure - too low pressure").
Program supports report printing or copy to clipboard.
Clear fault
codes
This function clears all stored fault codes and other diagnostic
information.
Auto-scan (complete car
scan/test)
Detects all ECUs (electronic control units) installed in car and
reads all diagnostic fault codes.
Measured Values
Program displays live Data like Engine Speed, Battery voltage,
Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in
graph, 9 values at once, or full listing (all measured values).
Logging to file is also supported, which allows offline
analysis.
Actuator
test
Actuator test activates particular actuator (e.g. turn on fuel
pump, lock/unlock wheel, lock/unlock doors, cut off fuel,
etc..)
Programming
functions/Adaptation
This feature is of great importance in all vehicles because systems
like Engine control units, Immobilizers, Airbags, Alarms, Body
Control Units, and some others, require you to perform reset or
programming procedures after car repair is done, or even
configuration after replacing broken Control Unit.
Hardware and software
requirements
Software requires at least Intel Celeron/Pentium III **0 MHz, **8
MB RAM, *0MB free HDD space and USB 1.1 port (USB 2.0 recommended)
and branded Windows *8 SR2/***0/XP with the latest service pack
installed.
If customer requires, we can prepare ready to work PC.
Set
includes:
- Main unit with OBD*2 cable
- *6pin F to 2pin cable
- USB cable
- ISO cable for cars before ***1
- Software CD
