Sell Good Heavy 20000-200000m3 AAC Production Line

Description

Good Heavy best quality ***********0m3 AAC Production Line

We are most professional manufacturer of autoclaved aerated concrete (AAC) plants for more than *2 years, and we can supply complete set of autoclaved aerated concrete plant with *0 **0m3, **0 **0m3, **0 **0m3, **0 **0m3, **0 **0m3, **0 **0m3 capacity annually, including plant design, equipments installation, technical instruction, personal training, etc, and also can design and manufacture as per clients' requirement.     

Raw materials of aac line:cement, lime, sand, flyash, gypsum, aluminium powder, water

 Equipment list of aac line:
The equipment will be divided into two parts: specialized equipment and universal equipment.

 Specialized aac line equipment includes:
1. Cutting equipment: tilting crane, cutter.
2. Proportioning equipment: elecronic measuring scle, slurry beating machine, slurry storage tank, slurry mixer.
3. Pouring and autoclave equipments: aluminum powder mixer, pouring mixer, mould, side plate, autoclave truck, carrier car.
4. Enviornment protect equipments: dust remover.

 Other relative equipments as follows:
1. Cutting machine.
2. Tilting hanger, mould, side plate, hardening cart, mould frame, mould bottom, casting machine, hoist
3. autoclave, horizontal installation steam boiler.        

 AAC production procession:
The aerocrete produces the technological process:
1. The raw materials store in the material storehouse (or stores the pot) after dealing with reserve such as lime, cement, gypsum, sand (or fly ash)
2. Aluminium powder or aluminium lotion is through dealing with the reseve material for use
3. Raw materials measure according to certain matching by electron balance measure, aluminum powder, water put into aluminum mixer. it is suspends the liquid to make the mixture after measuring.
4. The batching water (cold water or hot water pitcher hot water) is measured by the electronic water balance.
5. Put into and pour among the mixers in certain order after, raw materails, aluminum powder suspend the liquid is measured, pour and enter the mould after mixing evenly (panel should be put network slice of reinforcing bar in advance in the mould)
6. Quiet to is  it raise in advance to park through certain temperature and time, is it transport to the cutting machine to hang from upset hoist upset *0 degree after the base body reaches certain intensity, the drawing of patterns is cut
a. The base body carries on the side and cuts and mills through vertically at first
b. Then carry on the vertical level to cut
c. Cut horizontally finally
d. Cut good base body raises to cauldron car go on one yard of shelves organize into groups to steam to transport to hang to drive a vehicle to load.
7. Raise products well, produce after the cauldron breaking the board off the fingers and thumb by the board breaking off the fingers and thumb machine to steam
8. Pile from finished product hoist or forklift to finished product field pile the buttess according to specification to carry
9. Steaming and raising the car and side board and entering the next board of circulation and returning after, the finished product is unloaded, with upset hoist mould frame association the drawing of patterns get off, restore *0 degrees return to pour mixer pour again after clearing up.