|
Injection Molding ,Thermoplastics,Thermostat for Plastic Injection Molding Equipment
1ã€Hot medium liquid: water or oil convertibly.
The water or oil can be used as a hot medium liquid according to the needs of mold forming temperature. Its high selectivity is certain to bring in high economic efficiency.
2 Vertical pump.
The flow of vertical pump can be always kept steady and its service life keeps long.
3 Stainless medium tank.
This interior tank will not get rust for long term, which is sure to prevent from any blockade of pipes and keep long-term service of pump.
4 Transparent water [oil] level viewer.
The transparent water [oil] level viewer can easily be used to view and inspect the quantity of medium liquid and be reminded to refill the medium liquid from time to time.
Injection Molding ,Thermoplastics,Thermostat for Plastic Injection Molding Equipment
5 Automatic alarming device.
While water [oil] shortage occurs in the container, this device will automatically light up and start alarming and cut off the electric power of heaters and pumps, thus to guarantee their safety.
6 High-precision automatic temperature control.
The measure of temperature is very sensitive and accurate, little change of temperature helps to keep products both fine and delicate.
Injection Molding ,Thermoplastics,Thermostat for Plastic Injection Molding Equipment
7 Minimize products wastage.
The mold can reach the required temperature right at the beginning of operation, thus can obviously minimize products shortage. Maintain proper temperature.
Either in continuous operation or in temporary shutting down, moldforming temperature can always be kept proper to guarantee the best quality of products and further improve the forming process.
8 Compact in size, light in weight.
Easy to install, convenient to operate, convenient to move and little room to occupy.
|
