Description
Features:
1, strong cohesive force, can be
well attached to the wall and coating
2, the putty has certain
penetrate ability, can close the pore on the surface and formulate
a waterproof layer on the surface
3, good flexibility, can meet
the requirement of elasticity modulus and keep the elastic coating
and the base surface from easy peeling
4, good anti-crack function, can
effectively prevent the bottom layer extend toward the
surface
5, excellent anti-aging function
and good anti-corrosion, non-toxic, harmless and environmental
friendly product
Application:
This product is suitable for the
surface system of requirements of primer and flexible waterproof
coating systems and exterior insulation finish systems
Operation Process:
1, the ratio: *5kg powder +
2.5kg additive + appropriate water, *5kg powder + *0kg additive +
appropriate water
2, pouring the additive into the
container then adding the powder slowly and appropriate water,
stirring them into particle paste with no powder no
deposition
3, if the wall is too dry, wet
the wall before operation, the substrate surface should be firm,
dry and clean, no grease, no wax, and other loose materials, for
the obvious pore or hole, harsh them with cement slurry, wipe out
the sharp edge.
4, using spatula to scraping the
slurry onto the surface, suggesting two times, each time keep the
thickness under 1mm, the total thickness should less than
2mm.
5, the second time of scraping
should after 6~*2h when finishing the first time
Technical
Reference:
|
Normal Amount
|
Technical reference
|
|
For the smooth surface, and the
thickness of putty is 1.5~2.0mm, ****0m2/set
|
1, operation: no scratching
barrier
|
|
2, dry time: ≤5h
|
|
3, initial drying crack: no
crack
|
|
4, surface PH: ***0
|
|
5, water absorption:
≤2
|
|
6, bond strength:
≥0.6
|
|
7, the dynamic crack resistance:
≥0.3mm
|
Cautions:
1,do not scraping again and
again, finish it within one time
2, after operation, take
measures to prevent raining, hot heat, and froze at first
*4h
3, the mixed lacquer putty
should be used up within 3h, never mix the dry slurry with water
and use again
4, this product requiring
operating under 5℃~*0℃ situation, never operate under
raining.
Store Method:
Store in cool and dry place, for
the liquid group should stay in the environment above 5 ℃,
unopened product can be saved for one year.
Packing:
*5kg powder + 2.5kg additive, *5kg powder + *0kg
additive
