Description
Features:
1, this product is a new type
strong adhesive, applied to all kinds of ceramic tile and stone
material paste
2, no need to wet the brick
wall, effectively improve the efficiency
3, strong bond ability,
material-reducing, much safer and firmer than the traditional
cement adhesive, also can reduce the construct trash and the
quantity of the wall
4, good anti-infiltration and
anti-aging function
5, can be used on the uneven
surface or smooth cement floor
Surface Treatment:
the substrate surface
should be firm, dry and clean, no grease, no wax, and other loose
materials.
Operation Process:
1, the ratio: MB general tile
adhesive: water: 3.3: 1 (*5kg/bag, about 7.5kg water) mixed and
stirred into paste, using an electric mixer to make particle paste,
put it aside for a few minutes and then a little stirring to gain
the better effect
2, using tooth scraper to scrap
the adhesive onto the surface evenly, control within 1m2, then push
the ceramic tile above it
3, for the ceramic tile with
deep ditch or stone material, expect for the surface, scrap the
backside of the tile or the stone material
4, leave 1.5mm joint space
between two tiles, suggesting MB-MC color anti-moldy gap
filler
Cautions:
1, make sure the smooth and
vertical rate of the surface before operation
2, for the water low absorption
ceramic tile or stone material, using with MB**3 additive or MB**5
marble tile adhesive directly (specific refer the MB**3, MB**5
product introduction)
3, finished after *4h, can be
walked or fill crack
4, operating under 5℃~*0℃
situation
5, can be used with brick crack
adhesive
6, never mix the dry slurry with
water and use again
7, clean the surface by little
wet sponge or cloth before it dry
Technical
Reference:
|
Coverage
area(amount)
|
Technical reference
|
|
1, coverage area differs
according to the circumstance
|
1, adjust time: about *5min
(adjust time: the effective time for the dislocation to
adjust)
|
|
2, using 3*3mm tooth scraper
about 1.7kg/m2
|
2, cool time: about *0min (cool
time: the longest cool time that the adhesive can last
)
|
|
3, using 6*6mm tooth scraper
about 3.0kg/m2
|
3, initial dry time: *8h(dry
solid water resistance)
|
|
4, dry time: *4h (according to
the weather)
|
|
4, using *0**0mm tooth scraper
about 4.5kg/m2
|
5, water resistance:
excellent
|
|
6, when dry, anti-weak acid,
anti-strong alkali and oil resistance
|
|
5, the smoother the surface, the
less amount
|
7, non-toxic, prevent
fire
|
|
8, cut
degree:＞1.2MPa (*4days later),＞1.5MPa(*8days later)
|
Store Method:
Store in cool and dry place,
unopened product can be saved for one year.
Packing:
*5kg/bag
