Description

System Multiplast " - a system of second generation. It is based on the so-called circulating electrolysis, which uses "dry" cell, where the plate is not immersed in water and the water is inside the cell. This design allows us to establish a system of "HHO CAR" under almost any hood, and delivers the performance **6 times more gas than normal electrolysis. System Configuration "MultiPlast": 1. Electrolyzer (Brown gas generator); 2. Expansion tank with water level; 3. Valve with the water level; 4. Accessories (hose, wire, clamps) 5. Instructions for connecting. 6. Electronic tuner to connect to the vehicle&#**9;s sensors (for injection cars) Application: A gasoline fuel injection, carburetor, diesel cars and cars on propane / methane engine capacity to ***0 cc Expected savings: When installing on engines up to ***0 cu. cm from the generator at least *0A - not less than ****5% fuel savings. ****5% savings are real, depending on the state tenicheskogo your car. System performance: 1 liter of gas per minute at *5 amps; 1, 3 l / min at *0A 2 liters / minute at *0A Dimensions: Electrolyzer - *0 mm x **0 mm Expansion tank - height **0 mm, diameter - **0 mm. Cost: **5 euros Room with electronic control unit for injection vehicles: **5 euro ================================================== ====================== 2. MultiPlast for cars and buses up to 5.5 liters. engine capacity. ****4 Volt The set includes: 1. Electrolyzer (Brown gas generator) - 2 pcs. assembly 2. Expansion tank with water level 3. Valve 4. Hoses 5. Clamps 6. Rello 7. Instructions for connecting. System performance: 2, 5 liters of gas per minute at *0 amps; Savings: at least ****5% depending on engine capacity. Application: injection, gasoline and diesel vehicles with engine capacity up to 5, 5 cubic meters. liters. The cost for diesel and gasoline engines: **5 euros The cost of electronics for fuel injection engines: **5euros.