Description

• Model name: SF*****-W*0(*0W/T****0MM/**0cm)
• Light source: **0pcs LED(DIP)
• Voltage: AC*5~**5V *0/*0HZ
• Color temperature: ********0K(warm white),********0K(commercial white),********0K(cool white)
• Luminous flux: ********0LM
• Energy saving: ≥*0%
• Lifespan: ≥****0hrs
• Work temperature:**7℃~*5℃
• Aluminum Shell+PC cover
• Inner carton size: ***0***0***0mm (6pcs/carton)
• External carton size: 1Features:
  - Direct replacement for traditional tubes
  - Long lifespan up to ****0hrs
  - Work without ballast and less energy consumed
  - Slow failure, minimum maintenance cost, the economic choice
  - Low operating temperature, produce little heat, recyle without hazardous gasse and materials, green choice...
  - Immediate start, no noise output, no humming and flickering, healthy and safe choice.
  - Shock Resistant, much more durable than traditional light sources
  - Rated to operate from **0° C to *0° C, perfect for environments with extreme climates
  
  Usage Instruction:
  A. When installing LED T*0 tube to the hanger with Inductive ballast:
  1. Take out the starter from the hanger.
  2. Take out the inductive ballast and connect the wire (Refer to the following drawing).
  (The tube can work normally without this step. But it is strongly suggested for energy saving since the ballast may consume much power)
  3. Install the T*0 Ceiling Lights into the hanger directly.
  B. Installing LED T*0 tube to the hanger with Electronic ballast:
  1. Take down the electronic ballast from the lamp hanger.
  2. Connect the wire. (Refer to the following drawing)
  3. Install the energy saving LED T*0 tube into the hanger directly. 
  **0***0***5mm (*6pcs/carton)
•