Description

As a high-tech indoor decorating material fashionable in Europe and America over the past years, the quartz wall covering has been widely used in hospitals, hotels, airports, office buildings, shopping centers, theaters and resident homes. Performance include: A composite decoration material with all natural textile, adhesion and coating into a whole body. A-class fire proofing glasstextile with natual and noninflammable property. Accepted safety and innocuity. Anti-staticelectricity. The freely breathing glasstextile with an unprecedentedly air permeability. Protection against shocking, cracking and insect biting with comparable strength. Even washing with water at ****0times, it still looks as original as new appearance. Accompanying the acidity and the alkalinity with repelling the corrupting infulence. Walldec wall coverings have kinds of patterns with abundance of color, they can make rooms warmly and romantic and healthy, have special noble and elegance effect. And they can change color for more than 5 times according to host&#**9;s different selection. Installation specification: 1. Smoothing Wall Surface Clean and smooth wall surface. Fill and smooth all holes or cracks in the wall surface with fillers. 2. Drawing a Vertical Line The installation of textile quartz wallcovering is usually started from a corner of walls. The width of the textile wallcovering is 1 meter. Draw a vertical line on the wall surface with pencil by means of a plumb. 3. Applying Adhesive Rolling apply the special adhesive for quartz wallcovering. The width of each time of rolling application should generally cover about 1.1 meter (I. E. A little wider than the width of the textile quartz wallcovering). 4. Putting Up Wallcovering Use an adhesive scraper to scrape over the wall surface lightly to make sure that the adhesive is distributed over the wall surface evenly and excessive adhesive is removed at the same time. 5. Trimming Fabric Edges Put up the textile wallcovering along the vertical lines drawn on the wall surface, making sure to reserve about 3 cm at each of the upper and lower wall corners for later edge trimming. When cutting and splicing are necessary, the two sections of wallcovering should be ensured to have an overlap of about 5 cm. Cutting in the overlapping area can only be made when the overlapped patterns have been checked for matching each other.