Phase Detector ETCR1000A

Description

Contactless! The voltage to be measured is inspected in the above No bare metal conductor, assure absolute safety clamp the wire about **0mm2 gain time, increase productivity Super induction slope mo alloy clamps, sensitive and reliable Inspect the live wire of wire, Inspect electricity simplely , judge lacks, search breakpoint, maintenan line Shutdown automatically , reduce the consumption of battery Low power consumption, canwork about *0 hours continuously Phase Detector ETCR ***0A This is a phase detector, designed to perform phase sequence checks and live line checks of a *-phase circuit using a static induction voltage clip. • The static induction voltage clips are used to be able to clip on a cladded wire. • It is small with a CAT â…¢ **0V safety rating. • Red LED lamps are used to make the indication visible in dimly lit areas. • The direction of phase sequence can be checked easily using the LED lamps, which blink in order. Basic Specifications Function Phase detection (positive/negative) Voltage detection method Static induction Object to be connected Insulated wire (nominal sectional area of the conductor: 2 to **0 mm², finished outer diameter: up to ø *7mm) Performance-guarantee voltage range *-phase, *0 to **0 VAC (sine waveï&frac*4;Œcontinuous) Operating frequency range *5 to *6 Hz Display Phase-detection indication Positive phase sequence: The four phase-sequence lamps blink order (clockwise) and the buzzer sounds intermittently. Negative phase sequence: The four phase-sequence lamps blink in order (counterclockwise) and the buzzer sounds continuously. Line-voltage indication R-S lamp, S-T lamp Power indication Power ON lamp: lights up (Power ON) blinks (Battery Low) General Specifications Operating temperature and humidity 0 to *0℃(*2 to **4℉), *0%RH or less ( with no condensation) Storage temperature and humidity **0 to *0℃(*4 to **0℉), *0%RH or less (with no condensation) Location for use Altitude up to ***0m(***2 feet), indoors Maximum rated voltage to earth **0V Dielectric strength 5.4kVrms Power supply Rated supply voltage 1.5VDC×2 Two “AA” size batteries Maximum rated power **0Mva Continuous operating time* Approx.*0 hours(Power ON, Standby state, using R6P manganese battery) *Battery life Auto Power Off (This function can not Be canceled.) The power will be turned off automatically if the Instrument remains idle for *5 minutes after the power is turned on. To reset, turn the power on again using the Power ON switch. Options Carrying case, Strap*, Spiral tube*, Instruction manual, Two R6P manganese batteries. *Attaching as the occasion demands. Cable length Approx.0.7m(*7.*6) Dimensions and mass Approx.*0W×*5H×*0Dmm(2.*6W×2.*5H×1.*8D) (excluding projections), Approx.**0g(7.1oz) Applicable standards Safety EN******1:***1, EN********1:***2 Pollution degree2, Measurement category CAT III(**0V)(anticipated transient overvoltage ***0V) EMC EN****6:***7+A1:***8+A2:***1