ULTRA WHITE CAULK

Description

KTR **0 ULTRA WHITE CAULK ELASTOMERIC ACRYLIC SEALANT **-Year Warranty (ASTM C *****1) PRODUCT DESCRIPTION: A one-component, non-staining high-performance with excellent resistance to air and moisture penetration and UV rays that cures into a flexible rubber sand gasket that will not crack, even after many years of outdoor exposure; can be paited over shortly after application with latex or oil paint. BASIC USES: Suitable for most interior or exterior applications. Seals cracks on concrete, drywall and wood; excellent for caulking around doors and window frames, siding corner joints, skylights, vents, air ducts and chimneys, where joint movement is moderate. PRODUCT ADVANTAGES: *Seals cracks in concrete ***0% paintable in two hours ***0% water cleanup *Mildew and moisture resistant ***0% flexible ***0% exterior / interior ***0% elastomeric * Non-yellowing white finish TECHNICAL DATA Percent Solids: *0.*0±1% by weight *5.*9±1% by volume Colors: Ultra white Weight / Gallon: *1.*5±0.5 lbs Viscosity: **0, **0 – **0, **0 cps. Flash Point: Non-flammable Drying Time: Tack free: *5 minutes To coat with latex paint: 2 hours To coat with alkyd paint: *4 hours Flash Point: Non-flammable Size: *0.*-oz. cartridge Theoretical Coverage: Approximately *4 linear feet of 1/4’’ bead per *0.*-oz. Cartridge. Surface Preparation:Surface must be free of dust, dirt, grease and mildew. Remove all loose or badly cracked sealant and paint. Mildewed Surfaces: Any existing mildew on the surface must be completely killed and removed prior to the application of new caulk. Using a long-handled brush, scrub mildewed surface with a mixture of one quart of household bleach and three quarts of warm water. Rinse completely and let dry completely. Previously Cualked Surfaces: It is critical to remove as much old sealant as possible before applying new caulk, spefially if it is cracked, eroded or pulled away from the joint. Application Instructions: For best results, follow these steps: (1) Apply at temperature above *0F (5℃) and when no precipitation is expected within *2 hours. (2) Cut nozzle to desired bead size (1/4’’ is recommended). (3) Hold tube at *5o angle to the seam and push KTR**0 ULTRA WHITE CAULK ahead of nozzle, applying uniform to the trigger in order to get a smooth bead. (4) Tool within *5 minutes with finger or damp smooth sponge. (5) Limit joint size to be filled to approximately 3/8’’×3/8’’. If depth of joint exceeds 3/8’’, use polyethylene foam or oakum as backup filler. (6) Wipe away excess with a damp cloth before surface skins. Drying Time: Wait two hours before painting with latex paint; *4 hours if using alkyd (oil based) paint. Cleanup: Clean up excess with damp cloth before caulk cures. Coverage: Approximately *4 linear feet of 1/4’’ bead per *0.*-oz. Cartridge. Storage: Protect from freezing; store in a cool, dry place at room temperature. Product must be used within one year of purchase. Note: Always use a sealer as shellac, before topcoating with a lacquer. Not recommended for use on horizontal surface where water may collect, or for marine use on areas below water level. Limited Warranty: Satisfaction guaranteed for thirty years. If porduct cracks, peels or separates while you own your home during periold of guarantee when used as directed, returen sales receipt and used container to KATER ADHESIVES INDUSTRIAL CO., LTD. Seller will not accept liability for mre than product replacement or purchase price. Notice: The technical data contained herin are true and accurate to the best of our knowledge. Published technical data and instructions are subject to change without prior notice.