PS Lunch Box Production Line

Description

Type: HB—**0/**0 Equipments&#**9; specification and allocation: NO. 1 extruder Baiting tundish matches with magnetometric bracket, charging equipment and roller to mix materials Screw diameter: **0 mm Screw matter: *8CrmoA1 steel after hardening and tempering, to deal with polishing after nitridize The cylinder outside screw matter: *8CrmoA1 steel after hardening and tempering, to deal with after nitridize Electric motor: 4 pole x*5 KW Electric motor controller: Frequency conversion controller Automatic temperature controller: *-section automatic temperature controller High-pressure butane pump: 1 set (Electric motor 5.5 KW) Show figure manometer: 1 set Mold head manometer: 1 set Full automatic hydraulic pressure changing net equipment: 1 set (Electric motor 5.5 KW) Electric appliance controller: 1 set Reducer match with screw: 1 set NO. 2 extruder: Screw diameter: **0 mm Screw matter: *8CrmoA1 steel after hardening and tempering, to deal with polishing after nitridize The cylinder outside screw matter: *8CrmoA1 steel after hardening and tempering, to deal with after nitridize Sheet width: ***0—***0 mm Foaming rate: *0—*2 Installed capacity: **0 KW Electric motor: 4 pole x *5 KW Electric motor controller: Frequency conversion controller Automatic temperature controller: *-section automatic temperature controller(cast aluminium heating collar) Electric appliance controller: 1 set Reducer match with screw: 1 set Cooling way: Recirculated water cooling with automatic controller Mold head: 1 set Cooling and finalize the design: 1 set of rounding knife Traction equipment: 1 set Electric motor: 4 pole x 2.2 KW Traction speed: 3—*0 m/min Rubber draw off roll: Traction way is to operate by using autologous friction force according to S direction 3. Wrap-up equipment: Air-powered bearing: 2 sets YLJ****6/6 moment electric motor: 2 sets Static canceller: 1 set