42 Servo Stepper Motor Kit With Driver Board | Suitable for 3D Printing | Compatible Mechaduino

Descripción del producto

 
Motor parameters:

Product Name: *2 two-phase stepper motor

Model number :*7HS***1

Step angle : 1.8 °

Maximum no-load starting frequency : ≥ ***0 PPS

Rated voltage 3.6V

Maximum no-load operating frequency : ≥ ***0 PPS

Rated current : 1.5A / phase

Phase inductance :3.7 × (1 + *0%) mH

Holding torque : ≥**0 mN.m

Phase resistance : 2.4 × (1 + *5%) Ω / phase

Positioning torque : *5 mN.m REF

Electric strength : AC**0V / 1mA / 1S

 

Wiring Instructions:

1. VCC : Connect ****0V power supply ( Refer to the working voltage of the motor, general *4V )

2. GND: Ground wire

3. CLK : Control signal (Connected to pulse  )

4. DIR: Direction control signal ( Floating forward, ground reverse )

5. ENA: Connect to enable signal ( Default enable, grounding stops working )

6. P2: Connect one phase to the motor on each side ( Refer to the motor parameter description,   the motor is divided into two phases AB, pins 1 and 2 are connected to one phase, and pins 3 and 4 are connected to the other phase. )

 

DIP switch {ON (1) / OFF (0)}:

1.Div1, Div2 control pulse frequency division

         (1) *0: 4  subdivision

         (2) *0: 8  subdivision

         (3) *1:*6  subdivision

         (4) *1:*2  subdivision

2.Ctl setting control mode, open-loop / closed-loop

          (1) 0 :  Open-loop mode

          (2) 1 :  Closed-loop mode

3.AC setting calibration

   Turn the AC to position 1, and turn on the power. The LED blinks 3 times to start automatic calibration. The motor shaft rotates counterclockwise for one cycle and then clockwise for one cycle. The system automatic calibration complete and the LED continues to flash. The AC dial returns to position 0, and then restart power.

 

Application examples:

1. 3D printing with fine closed-loop positioning
 

• Optical precision aiming (Laser, telescope, camera gimbal, etc.)
• Speed loop record player
• Force feedback / impedance control robot
• Force feedback of game controller
• Adjustable mechanical impedance: virtual spring, damper, etc.
•  Electric transmission device between two axes such as CNC machine tools
• Gravity elimination (eg: offset gravity torque on the robot arm, etc.)
•  Load detection and feature description (Used as a balance, etc.)