Descripción del producto

电子调温电阻炉 Electronic Temperature-regulating Resistance Furnace 使 用 说 明 书 Operation Manual 一.概述 A. Introduction 电子调温电炉是实验室常用的加热器之一，具有用途广泛、操作方便、用电安全等特点。 Electronic Temperature-regulating Resistance Furnace is usual heater in laboratory. It has the feature of widely used, easy operating and safety electric. 二.主要技术参数 B. Main Technical Parameters 型号Model DK***-II 工作电压Voltage **0V *0HZ 功率Heating Power ***0 W 炉盘尺寸 **5x**5 mm 外型尺寸 **5x**0x**0 mm 三.结构特点 C. Characteristics 电子调温电炉是采用可控硅电压电路调节，同时兼作电源开关，使主电炉发出不同的功率，适应不用功率加热的需要，以适一炉多用的目的。 Electronic Temperature-regulating Resistance Furnace adopts silicon controlled voltage circuit to adjust power and it is made as switch at the same time. It is fit for different heating power by adjusting the furnace’s switch. 四.使用方法 D. Operation Guide 电子调温电炉的标牌上都有明显的最大功率标志，接通与电炉相一致的电源，转动旋钮打开开关，使炉面发热，这时可根据被加热物的需要，调节旋钮的位置，确定炉面的使用功率，当旋钮右旋到最大位置时，炉面功率最大，反之则功率减小，这样可根据被加热物体使用温度的需要，确定旋钮的位置，打到理想的使用效果。 There is symbol of max power on the furnace label, and connect the same voltage as the furnace required. Turn the switch, then the heater begin to heat and set the temperature according to the heating products. Make sure the heating power by adjusting the knob. When make it to the right location, it is the max power, whereas, the power is lower. It can be settled temperature by the knob according to the heating products and make it to ideal using effect. 五.注意事项 E. Attentions 电子调温电炉采用铁路电热丝作为发热元件，结构形式为开启式，炉盘内电热丝当发红状态，在使用时其周围环境空气中应无易燃性，腐蚀性气体或导电尘埃存在，不宜剧烈震动，修理电热丝时，也不宜拉长或复绕。 The furnace makes rail heating wire as its heating component, and the structure is open type. Make there is no flammability and corrosion gas, electric dust or collision around the furnace when the heating wire is rubefaction. Do not prolong or circle the heating wire when repair it.