Stretch Film

Descripción del producto

It Packer Brand.
The most common stretch wrap material is linear low-density polyethylene or LLDPE, which is produced by copolymerization of ethylene with alpha-olefins, the most common of which are butene, hexene and octene. The use of higher alpha-olefins (hexene or octene) gives rise to enhanced stretch film characteristics, particularly in respect of elongation at break and puncture resistance. Other types of polyethylene and PVC can also be used. Many films have about **0% stretch at break but are only stretched to about **0 – **0% in use. Once stretched, the elastic recovery is used to keep the load tight.These machines offers safety for the products. There are two methods of producing stretch wrap. 1) Blown: the resin is melted and blown out, it is air-cooled. This is a slower process but provides for higher quality in all the areas listed below. The cost of production is also higher due to the quantity that can be produced per hour. 2) Cast: the film is passed over cooling rollers. This makes the cooling process quick. The quality is not as good as blown but more can be produced in an hour lower costs.
  Manual (or Hand) Wrappers: Extended Core: An extension of the film's core serves as a handle for wrapping; this type of wrapper offers little stretch control and is hard on hands. Mechanical Brake: A simple structure supports a film roll and a mechanical brake system provides resistance creating stretch of the film. Pole Wrappers: Similar to the Mechanical Brake system, but the roll and brake are at the end of an extended pole, creating an ergonomic design which eliminates the need to bend to wrap the bottoms of loads and strain to reach the tops of loads. Semi-Automatic Wrappers: Turntable Wrappers: The load to be wrapped sits on a turntable which spins the load relative to the film roll, which is housed in a carriage which can move up and down a fixed "mast". Stretch is achieved by rotating the load at a faster rate than the film is fed. Orbital Wrappers: The film is housed in a carriage on a vertical ring, the load is fed horizontally through the eye of the rotating ring, applying film to the load. A variation of an orbital stretch wrapper is a horizontal ring system, in which the load remains still while a horizontal ring is rotated around the load and moves up and down vertically relative to the load, similar to a rotary arm stretch wrapper. Rotary Arm Wrappers: In this system, the load remains still while a rotating arm turns around it wrapping the load. This system is used for light loads or for speeds which would otherwise cause the load to topple due to high rotation speeds.