Servo driver

Descripción del producto

Servo driver product introduction






1、 Features of servo driver
1. Quick response
Adapt to changing load conditions immediately
High performance fast function ring
Real time performance feedback
2. Stable and compatible
DSP processing task is more reliable and stable
Fully compatible with mainstream third-party rotating and direct drive motors

3. Safe and reliable
Reduce noise and additional hardware requirements
Over voltage, current and temperature monitoring provides higher reliability

2、application scenarios
Wide application, stable quality and large shipment。

3、Parameter table





The above parameters are for reference only. Our product technology is constantly updated and upgraded. At the same time, we also accept the customization and development of customers.




4、Product details




5、 Factory and qualification








6、Instructions and precautions
(precautions)
1. Electric shock hazard, the equipment must be connected to the power supply under the condition of protective grounding
2. Avoid the risk of short circuit by placing the driver in a damp place.
3. Do not use in dusty places.
4. Wear electrostatic bracelet to prevent electrostatic breakdown.
5. Crystal products may be damaged under certain conditions. For example, falling off the table or being impacted during the mounting process. If the product has been impacted, it is not recommended to continue to use it.
6. Exposure to radiation environment will cause damage to product performance.
7. Do not use or store these products in an environment where the pH range may cause corrosion or dissolution of products or packaging materials.
8. Do not use the product in halogen gas environment. Even a small amount of halogen gas, such as chlorine in the air or metal parts
used for packaging, can cause corrosion. At the same time, do not use any resin that will release halogen gas.
9. Store in indoor environment with temperature not more than 35 ℃, relative humidity not more than 75%, and no corrosive gas
(instructions for regular maintenance)
1. Clean the dust on the servo drive every quarter with a special cleaning solution. After cleaning the dust on the servo drive, dry the circuit board with a blower.
2. Every quarter, observe whether the electronic components in the circuit have the traces of high temperature, and whether the electrolytic capacitor has the phenomenon of bulge and leakage, if any, replace it.
3. Check whether there is crack or loose welding between pad and element foot of servo driver printed circuit every quarter, and repair welding if any
4. Retighten the interface screw of servo driver or replace the screw every quarter.
5. Check the capacity of the electrolytic capacitor in the servo driver every year. If it is found that the capacity of the electrolytic capacitor is less than 20% of the nominal capacity, it
should be replaced. Generally, the life of the electrolytic capacitor should be replaced after about ten years to ensure the working performance of the servo driver.


7、 After sales service
1. Our company can provide installation, debugging and technical training for all our products.
2. After the installation and commissioning, the warranty period is one year (except for vulnerable parts and artificial damage), with a lifetime warranty.
3. Irregular on-site maintenance, on-site operation and technical training.
4. After sales contact: 0571-89167832.
5. Service content: in case of equipment failure, first communicate by phone. If the problem cannot be solved, our company will rush to the site as soon as possible to solve the problem. After sales service includes not only equipment maintenance, but also technical support. Our technicians can carry out on-site technical training and provide a complete set of solutions. Professional and technical
personnel shall follow up the use of user's equipment at any time.