SD-AEB1 Modularization Analog Electronic Training Set

Descripción del producto

Product Introduction
1. The experimental circuit is designed in the way of unit circuit. The unit circuit is the basic experimental circuit, and then other components are added as the parameters of the circuit, or combined with other unit circuits to complete different experimental requirements.
2. The experimental schematic diagram is printed on the surface of the panel, and the experimental circuit is built by students according to the experimental schematic diagram.
3. The experiment connection jack adopts the overlapping self-locking gold-plated jack, which is fixed on the experimental board by welding.
4. Discrete component zone, can plug resistors, capacitors, diodes, transistors, integrated circuits, etc., can carry out course design experiments.
5. The output of the power supply has over current protection and automatic recovery function.
More Electronics training products, on tvetlabtech(a)aliyun com
TECHNICAL PARAMETERS
More Electronics training products, on tvetlabtech(a)aliyun com
1. Power Input: AC **0V±*0% *0HZ;
2. Power Output:
(1) DC±5V/1A    DC±*2V/1A
(2) From DC*1.*5V to **2V/0.5A; from DC*1.*5V to **2V/0.5A .
The voltage is continuously adjustable
(3) AC7.5V×2/0.2A
All the above DC power supplies have overcurrent protection and automatic recovery function.
3. High precision DC Signal Source
Max. output voltage range: from **0V to **0V; Max. load current *0mA, precision: 0.*1V,
continuously adjustable;
4. Function generator
Waveform: Sine wave, square wave (Duty cycle is adjustable), triangular wave; sawtooth wave, pulse wave
Frequency range: 0 to 2MHz;
Amplitude: 0 to*0V(V_P-P)
5. Discrete component circuits:
Integrated operational amplifier and amplifier circuit, rectifier, filter and voltage regulator circuit; Single stage amplifying circuit, two stage resistance-capacitance coupling amplifying circuit, negative feedback amplifying circuit; Emitter follower; Differential amplifier circuit; Complementary symmetric power amplifier circuit; Field effect tube circuit; Resistors, capacitors and diode, triode; Potentiometer group, bulb, loudspeaker, etc.
6. Discrete component zone
(1) Supply *6 of resistor-capacitor unit, 2 of triode jack.
(2) Supply 1 of *0 chip locking socket
Connector: 2mm inner diameter self-locking socket can be folded plug
7. The kit structure: aluminum alloy frame structure, overall size: approx. **5mm×**5mm×**0mm;