ASTM D4170 Fretting Wear Protection by Lubricating Greases Tester standard bearing automatic alarm anti fretting wear equipment

Descripción del producto

Fretting Wear Protection by Lubricating Greases Tester        ASTM D***0
Product model: JF***6

Product Introduction
This instrument is used to evaluate the anti-friction wear characteristics of the grease when the bearing swings. Under the specified test conditions, it can distinguish the low and medium-high anti-fretting wear capabilities of different greases. This test has been applied to predict the anti-friction wear resistance of automobile wheel bearing grease in long-distance transportation. The test principle is to make two sets of thrust ball bearings with test grease at an amplitude of 0.*1, an oscillating frequency of *0HZ, a load of ***0N, and room temperature conditions for oscillating motion. The test time is *2 hours. The average value of the sum of the mass loss of the two sets of bearing races is used as the evaluation of the anti-fretting wear performance of the test grease.

Technical Parameter 
1. Applicable standard:  ASTM D***0
2. Swing mode: motor drive
3. Swing arc: *2 degrees
4. Swing frequency: *0HZ
5. Bearing load: ***0N
6. Running time: *2 hours
7. Frequency control: frequency converter
8. Power supply: AC**0 *0HZ
9. Power of the whole machine: **0W


Main Feature
1. Two sets of standard thrust ball test bearings, with an inner diameter of *6mm±0.**5mm and an outer diameter of *5.*9±0.**5mm;
2. The frequency converter controls the motor to increase the control frequency, and the operating frequency is digitally displayed;
3. High spring guide cylinder, length *1.*5mm±0.*5mm, outer diameter *3.*2mm±0.*5mm, inner diameter *3.**4mm±0.**3mm;
4. Swing bearing seat with fixing screws;
5. A set of standard fixtures;
6. Digital display time controller, the test time reaches the buzzer prompt;