Aluminum-Plastic Composite Panel Production Line

RFQ Details

This equipment (the continuous combination line) has two styles: one is CJMFH 1300/1600-I,
which is extruding machine on line; the other is CJMFH 1300 / 1600-II,

which is PE extruding machine not on line but PE combination after rolling. These

two types have their own advantages.

Advantages of CJMFH 1300 / 1600-I:
1) Saves the PE plate material as well as the unrolling and warming up
consumable
2) Easy operation: it doesn't need to roll the PE plate
3) High rate of finished products: one percent higher than CJMFH 1300 /
1600-II

CJMFH 1300 / 1600-II:
1) Advantages:
a) High speed of finishing products: reaches 4-5m/min because it's not
subjected to the PE extruding machine's control, thus its cost for each
square is comparatively low
b) High yield rate, because all the unqualified goods can be reproduced until

it's qualified
2) Disadvantage: high cost in warming up the extruding machine and rolling up
the PE plates

These two kinds of lines are the same from the preset macromolecule film to the finished
products plat. They are automatic to set the PE plate of certain strength

to the preset annulus to make the film combined with the plate. Then this
combined material will be sent to be combined with the pre-warmed aluminum
roll.

After several times' combination and level off, and if it's molded, it's then sent

to the cool oven for cooling. Then the cooled plat will be covered by a protecting

coat and sent to the trimming machine then cut according to the customer's requirements.


Considering of the above advantages and disadvantages, we recommend the customer
to analyze his own condition and the benefits so as to choose the

proper style of this machine. On the other hand, our company is capable of
designing new machines according to customers' requirements.